|
Silverguard Car Cover Installation & CleaningInstallation:The installation process begins with positioning the Silverguard Car Cover over the central vehicle point and opening it. After that, if your Silverguard Car Cover is equipped with mirror pockets, place the mirror pockets of your cover in their respective positions As soon as you finish off with covering the mirror pockets, you can move ahead to cover the front and rear bumpers of your vehicle with the Silverguard Car Cover. As your Silverguard Car Cover installation is completed, be assured that the elastic fitted at the end portions of your cover would keep it perfectly in place and not allow to fall off at any cost. Cleaning: Silverguard Car Cover is properly washable through hand washing as well as via machine use. The hand washing process proves handy for Silverguard Car Covers that are not considerably dirty. You can clean the Silverguard Car Cover via simple hand wash. Instead of cleaning your Silverguard Car Cover via hand washing, you can also spot clean your Silverguard Car Cover with the help of automatic speed control washers (M/Cs). Only large M/Cs would be practically useful for you as in small M/Cs, the washing space is considerably small. You should never use agitators in machine cleaning as the use of agitators is likely to rip apart and tear off your Silverguard Car Cover. Altogether, it is also a significantly easy to start cleaning your car cover by bringing the inner cover out and then cleaning it by spraying water. It is especially necessary to use a bio-degradable, non-caustic, non-toxic and eco- friendly anionic detergent for the purpose of washing your Silverguard Car Covers. For proper washing, you should take this liquid cleaner in two cups and mix it with warm or cold water before soaking the cover in it for a brief 5 minutes period to release the attached dirt particles. Thereafter, you can wash the Silverguard Car Cover with gentle cycles for a period of 5 minutes and as soon as it is completed, you can start a two cycle rinsing of your Silverguard Car Cover with cold water. Now, as you rinse the cover with one cycle, it is made half dry and after that as soon as you position the half dried cover over the vehicle, the affect of air makes your Silverguard Car Cover completely dry. The important fact to be noted with regard to this washing procedure is that it offers superb protection to the fabric finish of your car cover. Important Note On The Cleaning Process: It is to be noted that the cleaning process becomes successful only within the 20-27 degree centigrade temperature range. Altogether, you should not use automatic dryer and also dry cleaning of your Silverguard Car Cover by any other means is also not recommended.
Colors & Materials
CUSTOM SEAT COVERS
CUSTOM CAR COVERS
CUSTOM DASH COVERS CUSTOM FLOOR MATS WOOD DASH KIT GALLERY
Installation & Cleaning
Seat Covers
Car Covers
Dash Covers
|
SHOP NOW